Immersion with Jono 3D printing

Immersion with Jono is very enjoyable. We are trying to design a playground using different shapes and sizes. I am considering on making this my project. One of my highlights are printing our playground and making it. One of my challenges are learning how to use the tools and where to find them.

Comments

Post a Comment

Popular posts from this blog

Maths

For this block of maths we are doing multiplication and division. I am in the stage 8+ group. We are doing powers and a task called seventh heaven. We have to research the number 7 in different cultures, the number 7 in religious, the number 7 around the world and anything else we have learnt about the number 7. Next we had to work out what was 777^7. I did this by doing 777^3 then 777^4 and multiplied that together and got 170,980,716,079,866,232,953. After that we needed to do some practise  work on mathsbuddy . Our tasks were powers/exponents and a pre-test on multiplying and dividing decimals.
Read more

Project presentation Hovercraft

Image
On Monday the 21st of August we presented our projects. My project was successful, however we had a problem. The frisbee that was supposed to be screwed to the bottom always popped off and we didn't know why, so we took it off. As we presented we did a contest, whoever can guess how long it takes to fill the skirt with air wins. We timed it and it took 2.50 seconds. Before we presented we made a imovie  with all our pictures videos and timelapse . Before we showed how the hovercraft works we presented our science board. Overall I think our project was successful.
Read more